? about the tap program

[puma85]

in the tap spine calculator theres an option for overdraw,

1. would all rest have an over draw basically? If, they weren't contacting the arrow at the center of the berger hole? so then if i have my whisker biscuit setup approxamately 1 inch from the berger hole would i then enter 1 inch into the overdraw option.

2.i played with this a little bit, if i moved the rest back to say 2 inches from the berger hole the calculator shows that my spine thus weakens. this would work for me to take a shaft thats in the red on the calculator and make it green by adjusting the rest in and out.

am i correct in my thinking?

[TAP]

Most modern bows with a normal rest.....(mounted to the burger hole and falling to the shelf) do not require you to adjust this. In your case If you are 2" back then I would use 1" as reference. I doubt you can bring an arrow from Red to Green by adjusting the rest unless you are going from 0 to 5"....

This is will not be an option in the next rev coming out next year. Todays bows just done need overdraws and how they were intended to be used.

[puma85]

im shooting a whisker biscuit arrow rest, and it is mounted 1 inch from the center of the berger hole to the center of my rest, what i was wondering was if this would be considered an overdraw since the arrow doesn't contact the rest at the center of the berger hole.

[TAP]

im shooting a whisker biscuit arrow rest, and it is mounted 1 inch from the center of the berger hole to the center of my rest, what i was wondering was if this would be considered an overdraw since the arrow doesn't contact the rest at the center of the berger hole.


I would neglect it as a variable..............