TAP

[thndrr]

when putting arrow info in (ie shaft length) do you use actual shaft length or length from nock throat to end of insert ?

Thanks,
Jim :?

[TAP]

TAP has two places where you enter arrow info and they are different. In the spine area that would be SHAFT ONLY length. On the main input form that is the finished arrow length which is nock groove to tip.

[thndrr]

TAP has two places where you enter arrow info and they are different. In the spine area that would be SHAFT ONLY length. On the main input form that is the finished arrow length which is nock groove to tip.

Thank you ! :D I should have been more specific :roll:
Jim