Tying servings for Fall Away rest

[archeryman]

I am looking for some info on how to tie in the pull cord for a fall away rest. I have just bought a G5 rest and need help in tying in the pull cord. Any help would be appreciated.
Eric

[MoTribute]

I don't use a fall away type of rest, So I don't know how much help I'll be, but I'll try. I know there are some cable slides that you can buy that has a way to attach the pull cord to it without haing to tie it into your cable. Here is a link maybe this will help you.

http://www.cabelas.com/cabelas/en/templates/product/standard-item.jsp?id=0046556417950a&navCount=9&podId=0046556&parentId=cat600816&masterpathid=&navAction=jump&cmCat=MainCatcat21424-cat600816&catalogCode=QZ&rid=&parentType=index&indexId=cat600816&hasJS=true

Good luck, and if that wont fit what your looking for, I'm sure someone will be able to help you out better than I could...lol

[meanmike]

Well on mine, the dealer put the cord thru the cable, and then tied a knot in the cord, and then put serving above and below the cord to keep it from moving.

[larcher]

I also tie a knot onto the buss cable and place a brass nock over the knot instead of a serving. IMO a brass nock is less likely to slip.
good luck

[mobow#1]

Both will work:wave: